Beam Splitter Gratings for Spectral Monitoring
Self-amplified spontaneous emission (SASE) is currently the most common method for the generation of short radiation pulses at x-ray free-electron laser (XFEL) facilities. Due to its stochastic nature, the pulses produced fluctuate both in intensity and in spectral composition. These fluctuations can affect the measurements performed at XFEL facilities. To mitigate the effect on experimental results, it is crucial to develop a diagnostic tool capable of providing well-resolved spectral measurements for each individual pulse. In the hard x-ray energy range it is difficult to conceive spectrometers that does not compromise the quality of the beam delivered to the experiment. We developed two different spectrometer setups that use non-invasive, radiation hard and highly transmissive nanostructured diffraction gratings made of diamond. These gratings act as beam splitters by diffracting away a small portion of the main beam (~1%) which will be used for monitoring purposes. The remaining beam will be transmitted through the grating, and are available for the experiment.
One spectrometer type is based on an off-axis focusing Fresnel zone plate and a fast-frame recording device used to monitor the diffracted beam (Figure 1). The device was tested in the full beam of the XFEL at the Stanford Linear Accelerator, US .
It proved to be radiation hard under full radiation load, and was capable of recording single shot spectra with ~1.5 eV resolution (Figure 2).
We have further developed the concept of beam-splitting to obtain better resolution by combining a nanostructured linear grating with a high-resolution diffraction crystal spectrometer (Figure 3) developed by a group at Stanford Linear Accelerator (SLAC), USA. The capabilities of this setup were demonstrated at the Linac Coherent Light Source at SLAC , using hard x-ray SASE pulses at a repetition rate of 120 Hz.
The recorded single-shot spectra had a resolving power of 3×104 (Figure 4) . The grating showed no degradation after days of exposure under such intense x-ray beam, satisfying the robustness required for experiment use, and no replacement or realignment of the grating was required during the measurements. The shot-to-shot spectral information can be used for the normalization of data obtained in scientific experiments. This type of spectrometer setup will be implemented at the two latest XFEL facilities: the European XFEL and the SwissFEL.
- P. Karvinen, S. Rutishauser, A. Mozzanica, D. Greiffenberg, P.N. Juranić, A. Menzel, A. Lutman, J. Krzywinski, D.M. Fritz, H.T. Lemke, M. Cammarata, and C. David, Single-shot analysis of hard X-ray laser radiation using a non-invasive grating spectrometer, Optics Letters 37 (2012) p. 5073
- M. Makita, P. Karvinen, D. Zhu, P. Juranic, J. Grünert, S. Cartier, J. H. Jungmann-Smith, H.T. Lemke, A. Mozzanica, S. Nelson, L. Patthey, M. Sikorski, S. Song, Y. Feng, and C. David, High Resolution Single Shot Spectral Monitoring of Hard X-ray Free Electron Laser Radiation, accepted in: Optica (2015)